I recently replaced my aging but well dialled in FLSun Q5 with an Elegoo CC2.

I am very pleased at being able to print much larger things, but I get this effect at height. This is an egregious example but even cleaner prints still have obvious layer shifts.

  • Bluesheep@lemmy.worldOPEnglish
    7·
    14 days ago

    I should say, I have so far changed to scarf joints, changed to normal z-hop and increased a-hop height.

    I also increased brim size, even though I had no evidence of lifting.

    • roofuskit@lemmy.worldEnglish
      4·
      14 days ago

      Just seeing this. If you really think this isn’t warping print a cylinder tower in the spot where this parts messed up edge was on the bed. If that prints with an issue in the same exact height, it’s a problem with your mechanisms, likely z axis.